Wallpaper Hanging Instructions
In order to make the very most of your new Cole & Son wallpaper, we recommend you or your decorator read the steps below before hanging your chosen design. You can get an indication of how many rolls you will need by using our roll calculator, just input the design dimensions from on the product page. Don't forget to allow for the pattern match as a large repeat or half/third match point can mean you will require more rolls. The pattern match will determine where the pattern joins at each side of a drop of wallpaper; ‘Random Match’ is where there is no pattern at the joining edge to match, e.g. a vertical stripe, 'Straight Match' is when the pattern repeats side to side on the roll and the pattern joins in the same place on the next drop of wallpaper, 'Half Drop' is when the pattern repeats diagonally across a wall and the pattern match from side to side drops down one half before repeating, 'Third Drop' is similar, but the pattern match drops down one third before repeating.
Before hanging your wallpaper, check that rolls are undamaged, that the product code and batch reference are the same for each roll and that all colours match.
Please check which way up the design should be and if in doubt, speak with your retailer or view the design in situ via our Instagram.
Tools you’ll need to hang our non-woven wallpapers:
You will need the following:
- Paste – we recommend Cole & Son Tub Paste for all of our non-woven wallpapers; a specially prepared ready-mixed starch based paste
- Dust sheet or floor protection
- Paste brush or roller
- Sharp knife or snap off blade
- Plumb bob or laser level
- Clean sponge and bucket of clean water
- Smoothing brush or plastic smoother
- Tape measure
- Straight edge or metal ruler
- A pencil
- Soft cloth
- Felt or soft roller
- Artist’s chalk or pastel; to prevent white edges showing at the seams, dark coloured wallpapers may need their edges colouring with a slightly lighter chalk or pastel
To ensure a perfect finish, walls should be prepared correctly; all holes should be filled, walls should be smooth, dry and cleared of any debris. Walls must be primed and if necessary cross line with lining paper. Lining paper helps to even out slight imperfections acting as a base for your wallpaper. Turn off the power and remove all faceplates and socket covers.
Do not hang over glossy or non-porous areas. Painted walls should be rubbed down to remove grease or soiling and glossy paint should be rubbed down with sandpaper. Pre paste porous wall surfaces such as plasterboard or chipboard. Never hang over new plaster or un-primed walls.
Foil background designs can be damaged if high levels of alkaline are present in the walls. If in doubt, prepare the walls with an alkaline resistant primer before hanging. We recommend lining walls where highly metallic papers are being installed. If lining paper is being installed it should always be hung horizontally, following manufacturer’s instructions, and be allowed to dry completely.
It is the responsibility of the decorator to ensure the wallpaper is correct and, during hanging, to check there are no visible faults. No claim for hanging costs in excess of one roll will be accepted.
Check all wallpaper within 14 days of receipt; please notify your supplier of any faulty product. We cannot accept any responsibility after the wallpaper has been hung.
This information has been supplied in good faith but without guarantee.
Site conditions are beyond our control.